Removed and cleaned the battery leads on each battery, went from a dark brown/greeninsh to bright copper!
Also cleaned the post and bottom to a nice clean, what I assume is lead.
Haven't tested it yet, but at least I tried.
Also going to improve my dual amp wiring setup at the battery side, it...
Port Tach backlight was flickering for a few seasons now. Livorsi said it was probably the bulb 'holder'. so I went in, cleaned and adjusted the metal tabs a bit - no joy. Of course that was after I put it back together.
Pulled it all apart, replaced the LED bulbs with a new one, in all 3 of...
So, every summer my boat turns from nice white to brown from the tannin in the bay. and that's gross.
So, for fun I got $10 worth of PPF, and applied it a few areas and will update this thread in the summer and fall.
I also put some on the air intake where the water hoses lay when I'm flushing...
https://www.cnn.com/us/live-news/baltimore-bridge-collapse-03-26-24-intl-hnk/index.html
I've been on and under this bridge a hundred times. This is a gut punch and it hurts. I hope for the best for anyone involved.
https://www.amainhobbies.com/pro-boat-formula-fastech-brushless-deep-vrtr-prb3750/p30810
WHY Am I just finding out about this NOW?!
of course it was dropped years ago, but still.
Rid my boat and myself of the bad connectors.
if it becomes necessary, I'll wire in the better ones at some point, but that seems unlikely.
the prior connectors used lower than I'd like quality wiring and the wires would pull out from them much too easily. No thanks. Not on my boat.
well, the bad news is I hate the connectors I used on this panel SO much.
The good news is, (almost) anything is fixable with some cash and time.
Ordered some new 4 and 6 pins.
https://www.amazon.com/dp/B0C3VJ4LH8?psc=1&smid=A10FQ1DBQYUKN7&ref_=chk_typ_imgToDp
These are the ones I used on my...