Recent content by kboxx

This was the last picture I took of it after I pressure washed the side and scrubbed it for a few minutes. I didn't see any fiberglass or paint bubbling. It did get hot enough to melt the isinglass in the canvas and a slightly melted VHF antenna. The big issue for me was that the smoke was...

I had a 2007 Formula 310 SS that was in my shop when the BMW next to it spontaneously combusted. The boat has smoke damage and Progressive decided to total it. It's coming up for Auction next week. It has 350 MPI mags with 500 hrs. The boat ran great and was in fantastic shape. If anyone is...

I was wondering if anyone out there has one of the dinghy cradle systems on a 31/33 SS and if you like it? With standard davits and a relatively short swim step, I think the dinghy would impede getting on/off the boat. Thinking that a cradle system might push it back a bit more and make things...

I had a similar issue and ended up recovering all my doors and the cabinetry with 3M DiNoc. Attached is a door that was peeling. I took a heat gun and stripped off the old covering, sanded the door and applied the DiNoc. It's pretty easy and stretches around corners.

I have an 07 310 SS with the Kohler 5ecd generator. I can go to the generator, switch the toggle to run and it starts up and runs perfectly until I shut it down. If I then move the switch over to auto and try to start the generator from the remote panel in the cabin, nothing happens. The switch...

I had the exact same issue with a 280 SS Sea Ray. I bought the boat with 340 hours and it was on it's 3rd set of motors - all damaged by salt water intrusion. That boat had water mufflers. I ended up tearing out the water mufflers and installing "Y" pipes to push the exhaust through the drive...

I recently purchased an 07 310 SS and the front cuddy is bare with the exception of the Bathroom and Fridge/Sink/Microwave enclosure. I'm wondering if someone might be willing to share some pictures of theirs. I need to have all new cushions made, headliner replaced..basically the full pull...