Recent content by sgilfus

https://www.carbiepoles.com/where-to-buy

no easy way to do it. Although if its a full separation you can likely just get a spray adhesive. The "plastic" print wood lamination shrinks over time so that can make it difficult. I have a 34 PC and have the same issue. I am working with Ebelwood, who is the original manufacturer of the...

Just seeing this Marine Mat has a patent on a fiber-reinforced floor. Its all supposed to come up in one piece, versus others that come up in pieces. Was silly easy to stick down, literally just peel and stick.

thank you!

Of course and Thank You. I hope your project comes together well.

or simply support@formulaboats.com include the HID number and ask for the build sheet. They likely still have it with all the detail of what was built on your boat at the time.

What is the model of the new drawer fridge you installed in the cockpit?

2005 34PC TAG will give you this part number - ran me about $13 dollars. Cabin Entry door seal - #204360

In the 2005 34PC the aft cabin TV was hung on the door of the big cabinet in the aft and Formula wired an AC plug into that cabinet behind the door in the cabinet. I'm in the midst of replacing it and putting in a bigger TV but Formula changed the door and moved the door "handle" lower so a...

In the 2005 34 PC there was one in the aft cabin and one in the galley. The factory started installing them on the large panel in the aft cabin and we did not like it as it would be behind the aft curtains when closed. So we simply installed a larger 32" TV with an articulating arm into the...

replaced 31PC 2005 with West Marine 18" Stainless Steel

for most formulas it's the lewmar thruster - I have the 34 PC so the attached chart dictates a TT 140 2.2 for your it seems like the chart shows for 41' a 185 TT3.0 for reference: https://www.lewmar.com/sites/default/files/Thruster%20Guides.pdf

You should have two sets of bilge pumps and float switches. Atleast I do in my 34 PC 1) Bilge pump and two float switches in the engine bilge area. 1 float switch will be low on the bilge floor and the other float switch slightly higher with the bilge pump fastened to the hull. 2) Same setup...

Gustaf is right - Just use a flat head screw driver and the mesh - put it between the wood and the mesh screen and it will easily pop out. Pull the four screws from the speaker and there is plenty of room to work away. Just put in an RA770 in the same area in my 34pc

my sensors were not working... I did two treatments of the following and Voila everything started working again. Unique Sensor Cleaner Liquid for RV and Boat Black Water Holding Tanks 32 oz. - 41J-1 https://a.co/d/fLq9JG4