Search results


  1. F

    Fuel sender float does not float in Gasoline

    My port fuel gauge always indicates empty, I pulled the sensor and tested it, and it worked perfectly, Turns out the float will float in water but sinks in gasoline, I need to purchase a new float, or revive the old one, To this point I have had no luck getting just the float, they want to...
  2. F

    Clicking noise when fresh water tank is nearly full

    Boat is a 37 pc and has a single fill point water system and Tankwatch 4 sensor system This 1st part seems normal When filling my fresh water tank and it’s nearly full I get a clicking noise from under sink, from the “Tankwatch 4” control head “, since I am filling I can hear the tank filling...
  3. F

    Actuator water drain

    2003 496 mag, On port side of each engine there is an “Actuator assembly water drain” (at least that is what the parts book calls it). On both engines the 1/8” x 40” rubber hose that comes off the top of the unit, is not connected to anything, should it be connected to something, if so where...
  4. F

    Salt Pile buildup on bilge on transom assembly

    My new to me 2003 37PC outdrive, 496 Mag has salt Crystals are all over the transom assembly 1 to 1.5 deep on the horizontal flat surfaces. It seems almost be a pile Kosher salt. Has anyone seen this? I now believe it’s caused from small exhaust hose leakage sending hot water into air, nearly...
  5. F

    Help 2003 496 MAG -starboard motor 2900 rpm max

    My new to me 2003 37PC with twin 496 MAG Does anyone have any ideas of what to look at, I have not had a mechanic look at it with proper tools, boat does not have guardian gauges, is there way to read codes without the Mercury tools, or have others had similar issue, and know what was...
  6. F

    Gelcoat are just behind windshield is checking

    My 2003 37 PC is developing checking in the gelcoated area of the walkthrough behind the windshield, is anyone else experiencing this and been able to repair to new standards. I am open to suggestions Sent from my iPhone using Tapatalk
  7. F

    Unattended electrical settings?

    What is best electrical switch setting for a boat in salt water 100% of the time. I have read that the 12 volt side of the boat can add to galvanic corrosion issues. My 37 PC has 2 - 12 volt main breakers, 2 - 120 volt main breakers Currently when I leave the boat unattended. Main electrical...
  8. F

    how to open main Electrical panel inside boat

    On my new to me boat a 2003 37PC I need to open the main electrical panel inside the cabin. It appears to have 2 white locks of some kind. That take a round hollow key. Now that I ask this question, is the center maybe a pushbutton? I have not tried anything yet. Does anyone have the same...
  9. F

    Awaiting Moderator review

    I have bee awaiting moderator review /approval for several weeks now I received the email to sign onto this site but have not been able to post in some of the subjects I have emailed the moderator. But have not heard back. I do not know if this is my issue or the sites. Sent from my...
Back
Top