2007 400ss - Has anyone upgraded to Bennett AutoTrim Pro System?


W

wcroland

New member
I was looking into this upgrade since my trim indicators are inoperable and I am redoing my dash as a winter project. Bennett says my sensors are likely bad. Just curious about how difficult the install and wire pull might be. My boat has diesels and access is impossible if you more than 4' tall and weigh more than 90 lbs. :).

Any feedback would be appreciated. Thanks!
 
I have autotrim with the 370 VP package, Never use it. Tabs are bennett trim is VP. Trim sensors on VP are mounted inside transom. Tab sensors are really oil level sensors in the Bennett pump.
 
I should not say I never use tabs, just not automatic. Tabs up, drives in, 3/4 throttle, comes right up on plane. Pull back throttle to settle in at 30-35 mph. Move drives out to neutral, you can look at indicator or you can feel when the ujoints are dead straight. Then a little tab based on where someone sits to get the boat level....thats it folks
 
You must log in or register to reply here.
Back
Top