Manual Toilet Issues


S

Schimdog

New member
I have a 2007 260 BR with a manual head.
The toilet will not draw water to fill the bowl.
I have checked the raw water seacock that is open
I can?t seem to see any other problems.
Just wondering if anyone else has experienced this problem and if so what was the solution.
Thanks
schimdog
 
Hey, someone else with a 2007 260BR!

I have found this usually to be a priming issue. It is a matter of getting a right hand workout to try and draw enough vacuum to get the flow started. Of note, if you close the seacock while not using the boat this will help tremendously in avoiding the problem in the future. Also, make sure the flush control is set to the solid arrow facing starboard

Past that you can either fix the pump seals or replace the until (They are only $150 or so). Its a pretty simple system, so there is not a ton that can go wrong with it.
 
It may be time for a rebuild kit if it hasn't been yet. The rebuild kit isn't all the expensive, or you can replace the whole flush assembly.

Mine (330ss) was able to suck water through a drained line with no issues at all. I put a quick connect in to back flush the line and kept it drained when not in use to avoid smell. So I suspect it's probably a mechanism issue vs priming.
 
Mine worked fine for a season-and-a-half all of a sudden second time out this season is stopped working. Would not pull water in. All I did was take the top pump half off and clean the rubber gasket And reinstall. I think the gasket wasn't sealing properly between the sandwich pieces and it's working fine now.
 
Thanks for the info I will try the priming method and I have ordered a new seal if the priming doesn’t work.
There is a you tube video on the system looks pretty simple.
 
You must log in or register to reply here.
Back
Top