These are the strips that are in the silicone tubing. Very hard to find something that will stick to Silicone. I fount a 3M tape that was $150 for a 50 yard roll. Has to different sides.. one that bonds to Silicone and the other to Acrylic. And it holds up good. Did have a few spots that let lose but used some locktite super glue.
thanks - got the roll and ready to install. One last question - can you tell me exactly how you powered? Where did you enter the hull? How big of a hole, how did you seal etc. Thanks again. Excited to get this done for 4th of July!
If you get the 12volt set you can power from the boat batteries. I ran power from a dash switch into the bilge ran the 12v to the controller. I cut the wire from the power supply 12v side and solder n shrink tube to switched 12volt supply. You also want an in line fuse! I used 2amp.