Latest activity


  • AllDodge
    AllDodge replied to the thread Low voltage problem?.
    Now if it used a isolator and one side was burned out then yes
  • AllDodge
    AllDodge replied to the thread Low voltage problem?.
    No manufacture does this from the factory, only why this would be setup to work this way is from some shade tree mechanic
  • S
    SabrToothSqrl replied to the thread Low voltage problem?.
    I'm very happy with my NoCo chargers. They have 1,2,3,etc chargers...
  • E
    earl1z19 replied to the thread Low voltage problem?.
    The way the formulas set up the battery charger wont charge the STBD battery unless you throw the parallel switch. Seems odd but its...
  • S
    switch or circuit breaker? I'm guessing the latter. I don't have a forward bilge pump, so I'm not that familiar with their use in that...
  • jetmart
    jetmart replied to the thread Cabin bilge switch? 350 CBR.
    I believe it is live all the time but you could try just lifting the float and see if it turns on.
  • B
    beanerwi replied to the thread Cabin bilge switch? 350 CBR.
    Two wires but wiring diagram shows two wires with switch.
  • S
    Does the existing pump wiring have 2 wires or 3? 2= hot all the time 3 = could be on a switch.
  • B
    I recently purchased a 350 CBR and found the cabin bilge full of water. The pump is faulty and I am replacing it with a new rule 2000. I...
  • AllDodge
    AllDodge reacted to GandDFreehold's post in the thread Low voltage problem? with Like Like.
    Thanks for the input guys. Batteries are 4 years old. I also replaced my Charles charger with one suitable for AGM batteries. I removed...
  • GandDFreehold
    GandDFreehold replied to the thread Low voltage problem?.
    Thanks for the input guys. Batteries are 4 years old. I also replaced my Charles charger with one suitable for AGM batteries. I removed...
  • AllDodge
    AllDodge replied to the thread Low voltage problem?.
    Might also check all connections for corrosion
  • AllDodge
    AllDodge replied to the thread Low voltage problem?.
    Agree with Gsent, your Bats are the initial issue. A AGM at 12.4V is 75% and going down to 11V is about dead While the boat gauge may...
    • AGM charge.jpg
  • G
    GSENT replied to the thread Low voltage problem?.
    I am not sure of your exact system but have heard that batteries need to be fully charged and in good condition on Axius systems. It...
  • H
    Hbrown reacted to Billy D's post in the thread Cabin door Adjustment with Like Like.
    Curious on how the door came out. After you removed the slide screws, the door just "lifted out"? I would have thought there would still...
Back
Top