So when you wrote "Item 9", you intended "Item 29". 9 is a screw, 29 is a sensor.. If yes, it's making sense now..
Found it on Amazon for $29 vs. $149 at mercruiserparts.com
Thanks AllDodge, much appreciated... but that link takes me to a page with parts for steering. Maybe you intended to use this link: https://www.mercruiserparts.com/bam/subassembly/31819/12826/295. Item 9 now shows to be a sensor. After adding item 9 to my cart, the description says its an...
Thanks AllDodge, I did call RawPumps and spoke to Joe Dubois regarding the pump that's listed on ebay (my 2nd photo). He took my engine serial number and sent me the same pump diagram you provided above. As you mentioned, he said I needed a slightly different pump. On this one, the rear of the...
1A030921 ... I did find one with the pulley already installed on Ebay, a re-built one that has a 90-day warranty. https://www.ebay.com/itm/Mercury-Mercruiser-Quicksilver-Raw-Water-Sea-Pump-46-8M0137215-8M0122652-OEM-/133071309931?_trksid=p2349526.m4383.l4275.c10#viTabs_0
2008 350 SS with 496 Mag HOs.. might need to replace my starboard engine raw water (sea) pump. Found this on Amazon, is it the right one for the 496 Mag HOs?
Quicksilver - Mercruiser 46-862914T08, 710-46-862914T08
2008 350 SS with 496 Mag HOs.. at idle speed, VesselView shows water PSI at 3.7.. starboard side is 17.9. Which is correct? .. maybe it's a failed sensor.. my water temps are the same, only see a difference in the PSI indicator. This isn't a new issue, has been this way for a year or so. I...
I ordered the same part number for my 2008 350. It came with the plastic sleeve. You may want to send it back to Lewmar and order from Defender. That's where I found mine.
If I cant sell my 2008 350 here in Fort Lauderdale, I may decide to take it with me to TX. With the move to TX, I am giving up my boat lift, so I will either rent a slip on a lake (either Lake Travis in Austin or Lake Lewisville near Dallas), or I can try to find a trailer for the boat and find...
Moving away from Florida and need to sell my 2008 350 SS. Unique feature is the hinged arch operated by a remote controlled windlass that allows operation from the helm, no 2nd mate needed to lower/raise the arch. I added the arch hinge due to fixed bridge near my home on the canals in Fort...
Per my related post (link below), I had to replace my port side starter solenoid. Its made by Intellitec, 12v, 100 amp. After replacement, my port engine now starts, but I noticed that the red indicator light on the starboard battery rocker switch no longer comes on when the switch is on. The...
Found the wiring diagram. I got the replacement solenoid installed and wired according to the diagram (see photo). The reason I needed the diagram is because my mechanic started this job and had partially disconnected wires, but stopped in the middle, then left without telling me (or showing me...
Of course, just before the holiday weekend, my port engine's battery disconnect relay goes out. Amazon can get a replacement to me on Sunday. No one in Fort Lauderdale carries them. Called TAG. OEM vendor is Intellitec. Part number 01-00055-000 12V 100AMP. Looking at my old one, it appears...
I did post this to Uship and got two quotes back. Total distance 1400 miles. High quote was $5k, low quote $4k, including fees and permits. Both are using low-boy trailers pulled by heavy duty pickups.