Search results

Looking to get new canvas done for our '04 31pc. Has anyone had new canvas made for their boat locally and was pleased with the job? I'll also check with Ameritex, but I may want the more rigid isinglass compared to the factory stuff. TIA!

The pan (left/right) function of my original ITT/Jabsco 5" spotlight stopped working, and ITT/Jabsco replacement lights are like $1,800. The motors are soldered, pricey (~$90) and somewhat hard to find. If you're not into repairing, I just wanted to let folks know that the Marinco/Guest 22040...

Last season, I had an impeller go out on the stb motor (350 MAG MPI). (I never change them until they fail because they're a bit of a pain to get at.) The first outing this season, I was in a rush and left the dock without checking everything over and quickly got the beeps. Turns out that same...

Last season, I had an impeller go out on the stb motor (350 MAG MPI). (I never change them until they fail because they're a bit of a pain to get at.) The first outing this season, I was in a rush and left the dock without checking everything over and quickly got the beeps. Turns out that...

About a week ago, I did a fairly lengthy write-up of how to convert your expensive Merc raw water pumps to inexpensive Johnson crank-driven pumps, and when I posted it, I got message that 'a moderator has to approve the post' or something to that effect. I don't see that post posted, and I...

I never change my impellers until they fail because it's somewhat of a pain. I changed one last season and ran OK but didn't prime right this season, and I burned it up. I pulled the pump housing (this is the bronze pump), and it had light scoring wear in it. The merc pumps are $$$, about...

I accidentally let the hatch (one above the forward bunk) slam down, and one of the supports came unglued from the hatch glass. Does anyone know what bowmar used to glue the support to the hatch? It looks like it could be a cyanacrylate (super-glue) type glue as there's not much - just a thin...

Hi, visiting from the PC board. The Admiral and I are thinking about moving up from our 31PC to a yacht in the next few years. However, I'm a bit apprehensive about the IPS/POD drives. Where we boat in the PNW, it's DEEP (like 400-600ft), and we do hit stuff from time to time. Also, the...

This is a little westerbeke 3kw that I installed. It quit all of a sudden after running for 10 min or so. Let it cool, and it cranks but doesn't start. I cleaned out a bunch if eel grass that got sucked into the sea strainer. I have spark. Will try some starting fluid, but then it's time for a...

We've always had our boat on a lift, but this winter we decided to put her in a covered slip for the winter. We've got B3 horizon motors with factory closed cooling (full). I use a bilge heater and in the past took out all the blue plugs in case the power goes out. This completely drains the raw...

LED-ing the whole boat and can't get the cabin lights off. I got the ones in the head which are the same fixtures, but I can't budge any of the cabin ones. Is it the tension from the headliner? Is there some trick that I'm missing? TIA

As some of you may remember, fuel economy was an important consideration when we were choosing between a 31PC and Regal 3260 as we make regular trips from Seattle to the San Juan Islands, about 80 miles each way. On our recent trip, I broke out the GPS & Diacom software and logged some...

This is an upgrade I just finished that replaces the old CRT TV in earlier PC's with a 19" LED flat screen, articulating arm, and blu-ray player. (samsung to match the microwave) Before: After:

Hi, I picked up a Westerbeke 3kw generator that I will be installing in our '04 31PC next month. Even though this is a different gen than the factory Kohler, I'd like to follow the factory setup for water intake and fueling as much as possible. Could someone do me a huge favor and snap a few...

A few months back, I asked for experiences with the 31PC versus Regal 3260 as we were shopping for our next boat. We were having a tough time weighing the relative merits of two particular '02 models. This forum put us deeper in the Formula camp, and while we didn't end up buying either the '02...

Anyone on here have experience with both these boats? Assuming the same price, condition, and equipment except for power - Regal has twin 8.1L, Formula has twin 6.2L - which would you go with (I know I'm on the Formula forum!)? Having been on a few formula regal cruisers, I'd say fit and finish...