Search results

I have a 2023 350 CBR. I'll be talking to the dealer but wonder if anyone else had a leak in this area. The water is actually coming through the bottom of the frame and through the screw. I cannot see where it is entering. I have temporarily put duct tape over all seals and corners. It is a...

Have 2023 350 CBR with Raymarine Axiom running Lighthouse 4 and Vessel View. I can't seem to find where to put in an depth offset to calibrate the depth. It seems to be measuring from bottom of drives. I would prefer measuring from water line.

Anyone know if there is a prewired coax cable for a TV in the cockpit that is downstream of the TV Antenna booster?

Has anyone figured out a flag holder for a small flag on the bow rail on a 350 CBR? The rail is not round so a typical mount likely will not work. Would like to avoid drilling into fibreglass.

New Formula 350 CBR with Vesselview. Also has digital "like" Gauges. Vesselview tank quantity will read full however the digital gauge only shows about 7/8 full. I found this percentage of 86% on the calibration page. What is this for? How do I change it to read 100%? Tank capacity of 162...

Formula 350 CBR with swim seat with boarding step. Does it lock in the down position while in use or is it meant to float up?

2023 350 CBR with Vessel View and Raymarine Axiom Chartplotter. Both of these units are showing speed in mph. The boat also has "analog looking" gauges and that speed is in Knots. I am told these gauges get their info from the chart plotter or Vessel View. Manual has not been much help. Any...

2023 350 CBR with Vessel View and Raymarine Axiom Chartplotter. Both of these units are showing speed in mph. The boat also has "analog looking" gauges and that speed is in Knots. I am told these gauges get their info from the chart plotter or Vessel View. Manual has not been much help. Any...

Just took delivery of a 2023 350 CBR. The way the cleat is located on the hull the spring line rubs on the side of the hull and potentially can damage the paint. Has anyone come up with a good solution to protect the paint?

There is not a lot of real-estate on the back of a 350 CBR. Where are people putting their boat names?

Looking to add autopilot to 2004 37PC with Volvo outdrives. It appears that Octopus mechanical remote drives are no longer available. What are people using to mechanically drive the steering?

I have a 2004 37'PC Volvo outdrives. If I have the engine battery switched off and battery charger on will these batteries still get charged?

I have a new 2019 centre console on Fresh water Lakes St. Clair and Erie. Looking to bottom paint. I am very familiar with Interlux VC-17 however VC Offshore was highly recommend. Any suggestions?

I am not near my boat. Looking for wattage of Stock Cabin Light Bulbs on 2004 Pc's.

Sorry for the redundant question. I have been searching the forum and most post are pretty old on the topic. I have a 2004 37PC with pot type lights in the interior cabin. Looking to replace with a simple plug and play LED bulb. Looking for exact part #, type, and if possible best place to...

I have a 2004 37PC and find the seats very uncomfortable. The seat bottoms just don't seem to have enough padding. (I'm not a big person either) Just wondering if the foam wears out over time or is this how they are built. I have compared to other non formula boats of the same vintage and...

On a 2004 37 Pc what does the Mid and Full lights mean on the the holding tank? Is MID half full? Is full completely full or do you have a few flushes after that light comes on? Any idea how many?

Anyone know off hand the brand of stainless Steal Boat Shore Power Receptacle on a 2004 37PC. I am hoping I can get away with only changing the interior. I have a fried prong.

I am looking at a 2012 and the build sheet shows the following under Standard features: 240Vshorepower w/fail-safe galvanic isolator & 50-amp cord w/Glendinning motorized extend/retract andstorage system • Is the shore power required supply 240 volt and not 120 volt?

I have 8.1 with closed water cooling and have a leak at the sea water pump. I assumed it was the large O-ring and replaced it. Now looking at it closer it is coming out of the hole shown in the pic. I assume it is the back seal shown in parts diagram numbered 6. Is this correct? How does one...