Search results


  1. FTL_Alan

    Is this the right part? Sea pump for 496 Mag HO

    So when you wrote "Item 9", you intended "Item 29". 9 is a screw, 29 is a sensor.. If yes, it's making sense now.. Found it on Amazon for $29 vs. $149 at mercruiserparts.com
  2. FTL_Alan

    Is this the right part? Sea pump for 496 Mag HO

    Thanks AllDodge, much appreciated... but that link takes me to a page with parts for steering. Maybe you intended to use this link: https://www.mercruiserparts.com/bam/subassembly/31819/12826/295. Item 9 now shows to be a sensor. After adding item 9 to my cart, the description says its an...
  3. FTL_Alan

    Is this the right part? Sea pump for 496 Mag HO

    Thanks AllDodge, I did call RawPumps and spoke to Joe Dubois regarding the pump that's listed on ebay (my 2nd photo). He took my engine serial number and sent me the same pump diagram you provided above. As you mentioned, he said I needed a slightly different pump. On this one, the rear of the...
  4. FTL_Alan

    Is this the right part? Sea pump for 496 Mag HO

    1A030921 ... I did find one with the pulley already installed on Ebay, a re-built one that has a 90-day warranty. https://www.ebay.com/itm/Mercury-Mercruiser-Quicksilver-Raw-Water-Sea-Pump-46-8M0137215-8M0122652-OEM-/133071309931?_trksid=p2349526.m4383.l4275.c10#viTabs_0
  5. FTL_Alan

    Is this the right part? Sea pump for 496 Mag HO

    2008 350 SS with 496 Mag HOs.. might need to replace my starboard engine raw water (sea) pump. Found this on Amazon, is it the right one for the 496 Mag HOs? Quicksilver - Mercruiser 46-862914T08, 710-46-862914T08
  6. FTL_Alan

    What is the correct raw water pressure for 496 Mag HOs?

    2008 350 SS with 496 Mag HOs.. at idle speed, VesselView shows water PSI at 3.7.. starboard side is 17.9. Which is correct? .. maybe it's a failed sensor.. my water temps are the same, only see a difference in the PSI indicator. This isn't a new issue, has been this way for a year or so. I...
  7. FTL_Alan

    Lewmar Chain Counter Sensor & Magnet Kit Compatibility

    I ordered the same part number for my 2008 350. It came with the plastic sleeve. You may want to send it back to Lewmar and order from Defender. That's where I found mine.
  8. FTL_Alan

    Need Advice On Buying Trailer for 14,000 Pound 350

    If I cant sell my 2008 350 here in Fort Lauderdale, I may decide to take it with me to TX. With the move to TX, I am giving up my boat lift, so I will either rent a slip on a lake (either Lake Travis in Austin or Lake Lewisville near Dallas), or I can try to find a trailer for the boat and find...
  9. FTL_Alan

    2008 350 SS for Sale in Fort Lauderdale

    Moving away from Florida and need to sell my 2008 350 SS. Unique feature is the hinged arch operated by a remote controlled windlass that allows operation from the helm, no 2nd mate needed to lower/raise the arch. I added the arch hinge due to fixed bridge near my home on the canals in Fort...
  10. FTL_Alan

    Trying to upgrade stereo

    Per the wiring diagram for the Kenwood KTS MP400MR on my 2008 350 Sunsport, that might be a sub output connection. I have two on mine.
  11. FTL_Alan

    Red Indicator Light on Battery Switch Went Out -- No Big Deal?

    Per my related post (link below), I had to replace my port side starter solenoid. Its made by Intellitec, 12v, 100 amp. After replacement, my port engine now starts, but I noticed that the red indicator light on the starboard battery rocker switch no longer comes on when the switch is on. The...
  12. FTL_Alan

    Any Advice for Replacing a Battery Disconnect Relay?

    Found the wiring diagram. I got the replacement solenoid installed and wired according to the diagram (see photo). The reason I needed the diagram is because my mechanic started this job and had partially disconnected wires, but stopped in the middle, then left without telling me (or showing me...
  13. FTL_Alan

    Any Advice for Replacing a Battery Disconnect Relay?

    Of course, just before the holiday weekend, my port engine's battery disconnect relay goes out. Amazon can get a replacement to me on Sunday. No one in Fort Lauderdale carries them. Called TAG. OEM vendor is Intellitec. Part number 01-00055-000 12V 100AMP. Looking at my old one, it appears...
  14. FTL_Alan

    Water Tank Leak-Diagrams of water lines/ideas

    TAG sent me this diagram for my 350, it was very helpful
  15. FTL_Alan

    What's the going rate for a boat hauler? FL to TX

    I did post this to Uship and got two quotes back. Total distance 1400 miles. High quote was $5k, low quote $4k, including fees and permits. Both are using low-boy trailers pulled by heavy duty pickups.
  16. FTL_Alan

    What's the going rate for a boat hauler? FL to TX

    I'm moving from FL to TX and am considering taking the boat rather than selling it in FL. 2008 350, 13,500 lbs, hinged arch to lower the min clearance to 7 ft, and beam under 11 ft (10' 9"). I paid $925 in 2015 to haul the boat 109 miles from Naples to Fort Lauderdale, so that was about $8.50...
  17. FTL_Alan

    Anyone else tried to repair Kenwood KTS-MP400MR head unit?

    Thanks jlanka.. here's a photo of the back of the Kenwood with all the required inputs labeled with a letter (A,B, etc.). Can you show photos or describe how you connected the existing wires that go into the Kenwood into the new Fusion? A) this wire goes to the stereo remotes at the helm...
  18. FTL_Alan

    Anyone else tried to repair Kenwood KTS-MP400MR head unit?

    My 2008 350 came with Kenwood's KTS-MP400MR stereo head unit. The AM/FM radio tuner just went out. I know its the tuner inside the unit because I have an alternate KTS (same) unit and the tuner works fine. I would swap them but there is also a problem with the alternate unit where it will not...
  19. FTL_Alan

    Need Photo of Sump Box - Mine is Jacked Up

    Here's mine. Looks like on mine they changed the cabin bilge to pump into the sump box, as there is a cut hose that would appear to have originally connected to the bilge pump and to the back of the compartment where you see the connection that has no hose attached. I don't see the advantage of...
  20. FTL_Alan

    Need Photo of Sump Box - Mine is Jacked Up

    Does anyone have a photo of the factory-original setup for the shower sump and hoses? For some odd reason, a prior owner changed my box's setup and I would like to understand what the original configuration would be. Thanks in advance.
Back
Top