Search results

My gen will not even turn over just some clicking and stops show the OC code. Doesn't matter if i try from gen or panel switch. I am showing 13.5 volts at the red wire connection on the starter synoid. To get it running i have to hook jumper cable of from house battery and go straight to...

I have the Dometic VG4 - some other manufacture name but same pump. I have rebuilt it 100%, all seals, o rings, motor, pressure switch, duckbills and its still acting up. Pulled it out again and totally disassembled and cleaned, reassembled, greased the seals and o rings, etc, new ductbills...

I have a 2008 400ss. The wife hosed / washed the cockpit the other day. She then found the carpet under the bed wet and the sheets wet. This was just the very corner of the bed in the farthest back area on the starboard side. So basically about right under the fridge. Another way to think...

Ok So i have have been experiencing a sewage odor in the cabin shortly after i drop the boat from lift and fire up the a/c. My a/c doesn't seem to have a lot of drainage from condensation and it works just fine so no need to divert over to that topic, I dont believe the a/c is the issue at...

I have noticed diesel exhaust odor in the cabin after we dock and kill the engines and generator. Our usual ritual is to start the gen and engines leave the dock, hit the cove with gen running all day and return to the dock and shut it all down. Sometimes we will go to lunch on the water and...

Been a lot of talk about different flooring lately with summer here. I just installed SeaDek. Really pleased with the results. SeaDek now has a template for a 48. Took me a lot of time and effort to get the templates all made up. If you do decide to buy some SeaDek drop me a message and...

Thought i would share some pics of my custom sun shade i had made for the 48. They did an incredible job. They even refit my isinglass around the frame.

I cross referenced my power steering filter and replaced it with a Wix. It is now leaking at the seal. I figure it may not have been a perfect fit cross over so with the correct part number i will get a new filter in there. If no has the number I'll call Formula.

My cabin sump that all the drains run into before pumping overboard has two float switches and two suction tubes, one large, one small. The pump that uses the large pu tube is not working. The float switch checks out fine. Does anyone have any advise as to where this pump is located or if its...

Anyone familiar with this Switch that powers up the amplifiers. The breaker in the engine room that says cockpit stereo amps allows the power to go through the switch. My question is, this switch with the breaker off, is 92 degrees with a laser temp gun seem a little warm? I have no idea if it...

I have water coming in my rear berth bilge, the one with ac strainers and pumps. It was very dirty water and and now it's clear water. I cleaned my engine room bilge area yesterday. I am thinking as the engine bilge pumps that the water out, it is back flowing some through the water discharge...

Does anyone know, does the generator itself have a built in charging system for its battery? I have the external Guest 6am charger. When it dies my gen runs until the battery is dead. I would think that it has its own charging system like some of our small machines at work that have Kohler...

The wiring for my toilet is exposed. It has been like this since new. Suddenly I feel concerned. Is there supposed to be a cover protecting it from or showers.

I have the factory Kenwood 10" subwoofer installed forward firing at the helm base. There is also a pair of coax speaker installed in the helm base. I haven't been able to find any info on here where someone has had the same setup and upgraded that sub and amp. My concern is a woofer and coax...

on my 37 pc i have group 27 batteries as my port and house. Now sure that it he correct size. They warrantied these right after we bought the boat. Looks like the 31's will fit. Anyone know what the default battery was in 2007 for a 37pc.

I am having some trouble with my toilet. Early this year before MM Day our toilet wouldn't quit building vaccum. I figure its been 6 years, its time to rebuild it. I pulled the pump head and replaced the duckbills, and the bellows which had a rip. Installed and it worked all summer. First...

Need some help. My through-hull underwater OceanLED light housings are corroding. I guess thats the best way to explain it. The boat had been floating for 5 years. At that time I had the boat pulled which was a little over a year ago for a bottom job. They blasted it, epoxy and painted the...

I finally decided to upgrade my TVs to digital. Thought there may be some interest. I removed the galley TV and covered the hole with a mirror and then tinted it for dark effect. I used thick aprox 1/4 glass. It is pretty close to the same weight at the tv, maybe little heavier. In removing...

I need some help please. I have 104 hrs on 8.1s. I did a full service this spring, impellers, fuel, oil and cleaned the air filters. Boat does not have all its RPMs. A WOT it only hit about 3k on sea trile. I backed off thinking it may be detonating. Little later it seemed to have full power but...

I'm being told 3 years or 300 hrs with the new brass housing impeller pumps. Anyone experience any issues running that long?