271 FASTech Bilge High Water Alarm Device Location


S

SpidRacer

New member
Trying to figure out why the bilge high-water alarm is not working. Float switch is working but no alarm if I hold the float "up". Tried doing it with ignition on, off, etc. Also held it for 20+ seconds in case there was some sort of timer, and still nothing. Is there a separate high-water alarm "buzzer/alarm" somewhere? Or does the system use the same engine/ignition alarm device?

Thanks in advance,

Pablo
 
Well, start with the power source and verify power at each location along the way. High water alarm should have a fuse/breaker, but no switch. 12v at battery? 12v at float switch? 12v at speaker when switch is 'on'?
 
Thannks. Yup, doing the electrical trace. That's why I am trying to find where the "speaker" is. Probably "hiding in plain sight" but have not yet found where...
 
Last edited:
You must log in or register to reply here.
Back
Top