Greetings,
My fresh water level gauge seems to be stuck at about 1/3 full. I discovered this when the water pump started to run continuously and the tank was empty. I filled the tank and the gauge still shows 1/3 full.
I figured that it was the level sensor, and expected to find an arm float type, or a tube float, but instead there appears to be three. None have the 3” plate with 5 bolts as I’m used to.
I’m going back down to remove one of what appears to be a sensor, and see what I can find about replacements.
Pictures are of the water level gauge, under the galley sink, the “front” sensor, under the head of the bed by the filler hose, and two under the foot of the bed, near the water supply hose. I also have the wiring diagram, which shows a single “Tank Level Sensor”, but does have 3 wires for Full, ½ and Empty. I’m guessing that I have 3 sensors for each water level?
Can anyone share their experience with sorting out fresh water tank gauge issues? Still a mystery to me…
My fresh water level gauge seems to be stuck at about 1/3 full. I discovered this when the water pump started to run continuously and the tank was empty. I filled the tank and the gauge still shows 1/3 full.
I figured that it was the level sensor, and expected to find an arm float type, or a tube float, but instead there appears to be three. None have the 3” plate with 5 bolts as I’m used to.
I’m going back down to remove one of what appears to be a sensor, and see what I can find about replacements.
Pictures are of the water level gauge, under the galley sink, the “front” sensor, under the head of the bed by the filler hose, and two under the foot of the bed, near the water supply hose. I also have the wiring diagram, which shows a single “Tank Level Sensor”, but does have 3 wires for Full, ½ and Empty. I’m guessing that I have 3 sensors for each water level?
Can anyone share their experience with sorting out fresh water tank gauge issues? Still a mystery to me…