I did on my 2004.
The factory uses Attwood Neat Cleats, although theirs are custom with the Formula logo.
I simply bought the cleats, measured 10x. Drilled pilot holes, measured again, drilled the final size.
I then carved out the coring by about a 1/2", taped the back side of the holes closed and filled them with thickened epoxy.
I then re-drilled and installed the cleats with 3M 4000 UV.
This is probably a better install than the factory.
I have photos of the factory installs, if you want PM me your email and I'll send them over.