Fuel gauges not working


formula40pc

formula40pc

Member
Any one have any problems with fuel gauges not working? 2009 40 PC with Volvo IPS 500. No reading on the EVC display nor the 4 in 1 gauge. Check the sending units and they show good. Ground wires were checked also. It seems to appear as a problem with the two units as something they share. Any thoughts?
 
formula40pc said:
Any one have any problems with fuel gauges not working? 2009 40 PC with Volvo IPS 500. No reading on the EVC display nor the 4 in 1 gauge. Check the sending units and they show good. Ground wires were checked also. It seems to appear as a problem with the two units as something they share. Any thoughts?
Click to expand...
I am hoping to solve the problem over the weekend. Followed the wiring and the pcu receives the signal then goes to EVC. Read more into it and started to look into the EVC. After reviewing it seems the fuel sensor are? not calibrated?. After more research I found the procedure for recalibration. Will attempt it this weekend
 
Not sure this helps, but years ago on my 353 Fastech, there was a breaker for the fuel sender. I had stowed a stern anchor under my back seat and inadvertently tripped a breaker marked “Fuel Sender”. Just a thought.

Dave
 
Not the case on this one but Thank you for your info. Seems it has to be programmed with the Vodia software. I have Eckels Diesel coming this week to program
 
You must log in or register to reply here.
Back
Top