Recent content by Slowlearner

Does anyone know if we have a anti siphon valve on these tanks...? I am chasing a fuel restriction on my port engine and before i have to climb in the storage compartment i am asking now....I checked the pickup for the genny and it does not but I dont know if the engine fuel lines do.....?

Has anyone had to service there Norscott seals...? Mine are leakin a bit of oil. I have cummins with 2" shafts...

Does anyone know the model number of the Kohler gennys used in the 41 in 97...? Its a 9k with a 3 cylinder diesel engine. The tag on top is barely legible and I cant read it...

From what ive seen the shore power cords seem to be wired to the boat. I hate cords and would love to possibly convert to a 50amp single cord that has plugs at both the boat and the dock. Has anyone done this...?

Do we know who made the Gear/Throttle controls for the early model 41PC's....? The chrome units with the curved shift levers....?

Does anyone know the model number of the cockpit fridge for a 41pc.....? This one is missing so i have no refrence.......

So fellas I had a post going about a " elevated " moisture reading in my center stringer. I am sure by now we all know that its a hollow box design. Well upon further investigation of the bilge and the stringer Ive found the entry point of the water. Formula has drilled 2 or 3 small holes in the...

When i bought the boat the surveyor touched on it briefly, as to make it seem like no big deal,and to be honest I dont think it is. I have now considered stepping up to a larger PC and now I have a feeling this may cause a issue... Its a 02 330 and i guess my question is, will this be something...

So I am lookin at a boat in Cape Coral Fl at a dealer, I am from Michigan. I was wondering if someone could/would possibly take a quick look at it and tell me if is worth my time to proceed. Obviously if your close and it not a inconvienience My number is 586-557-7385 My name is mark shoot me a...

So I am currently tossing around the idea of selling my 330 and picking up a 40ish PC diesel. I see the common power for these are the cummins and the volvo's. I am not diesel stupid by any means but soemtimes there is a preffered power and just wondered if anyone could shed some light on this...

So I have a new to me 02 330 with small blocks. I mostly boat on Lake St. Clair in Mi and we get quite a bit of peaky chop mixed with large vessel wake chop. The ride on this hull can be very rough at times, our cruise speed is 38mph. My question, is this normal or am I not my setting my...

Soooo, I am considering redoing my gauge panels on my 02 330. If i remove my tachs and my spedo can i just leave the harness behind the panel or do they need to be hooked up for proper operation..? Ive gone to the vessel view mobile and run all my gauges off a 10inch tablet...

Has anyone had any experience good or bad with ordering replacement canvas from Taylormade...?.....I want to say that the replacement bimini was 1200 and I dont think thats to bad....

Would anyone know the part# for the steering cable. I do not see one on the cable itself and my steering is very tight. With Formula being closed right now its kinda hard to source part numbers and to measure it while its on the boat seems near impossible..

Not sure if its the same set up or not...