Recent content by vmaxhp

Asking for a friend. Has anyone taken their PC from Tampa Bay area to the Keys? Seems like Key West is doable with a fuel stop along the way. Thanks!

Good morning! The front anchor roller screw backed out and the roller dropped into the lake. Anyone happen to know the replacement roller? TIA! Rick

2007 Formula 34 PC, 400 hours on twin 496 Mags Hull is the desired blue color. Bow thruster! RADAR, VERY well maintained. Upgraded speakers, bluetooth, smart TV in the salon. Interior lights changed to LEDs. Private sale at $99,999 -- way below market . I'm moving! Must sell

Anyone done their own valve lash adjustment? The rear rocker cover looks a pain to get to. Also, the flywheel cover has a lot of screws, some of which are covered by rigid pipes. Thoughts? Thanks!

I need to replace an IAC valve on my 2007 496 Mag. Looks pretty simple, but not sure where it is. Anyone ever replace theirs? Tips and suggestions? Thanks!

Good evening, I have an 07 34PC. The port stern drive trim sensor isn't working properly. The drive does go up and down with the switch. Just not being displayed correctly. Typically, that's the trim sensor. Has anyone replaced the trim sender themselves? How does the wire get routed in...

Eng Serial number 0w676269 Anyone? Manual #30 is for an older engine. Thanks! Rick

Eng Serial number 0w676269 Anyone? Manual #30 is for an older engine. Thanks! Rick

Looking for some exhaust parts. Here's a few prices. From where do y'all get engine parts? Part No Quan Michigan Motors PerfProTech Amazon http://www.mercruiserparts.com/ Shutter (Flapper) 807166A1 807166A1 2 $55.95 $74.08 $20.00...

Good morning. Yesterday, my starter went out. After boating for a bit, and then resting, the starter would engage, but not turn the engine. The generator had been running the whole time at rest, but I tried the parallel anyway. Same result. After a few attempts to start, the starter just...

My front and rear anchor Rollers are coming loose. There's a tapered bolt on each end of shaft on which the rollers turn. I was able to access the front and tighten. However, the rear bolt has come unscrewed to the point where the bolt is pressed against the side plate. This prevents the...

Good morning all. With humidity starting up in Houston, I thought I'd resurrect this discussion and see what others have done. The drainpan, while stainless, tends to collect upto about 3/4" of water when the A/C is used regularly. There is no blockage on the drain line going to the gray...

Well, looks like I'm going to need to replace the AC unit. Dometic SVCD18k/1HV 115v. No longer made. Looks like the replacement is DCU18K. Has anyone replaced their AC system? If so, with what? Thanks! Rick

I'm replacing the arch courtesy light and I noticed there's no backing plywood. Seems like there should be. I'm guessing when the radome was attached, the installer removed the block. Anyone confirm?

I need to replace the courtesy light fixture in the arch on my 2007 34PC. The plastic socket where you plug in the lamp has cracked and is now intermittent at best. Anyone know what fixture this is?